« previous next »
Pages: 1 [2]   Go Down

Author Topic: Heads with modified stems, ok for stock rocker shaft use?  (Read 6289 times)

0 Members and 1 Guest are viewing this topic.

Offline SuperSix

  • Administrator
  • Turbo Street Outlaw
  • *******
  • Posts: 5072
  • PSI: 234
    • View Profile
Re: Heads with modified stems, ok for stock rocker shaft use?
« Reply #15 on: September 10 2011, 09:35:04 PM »
Got some more info - 380.00 + 70.00 shipping..

" I mildly ported the runners.   I did not port the bowls. "

See anything I should be alarmed about?




Logged
'87 GN, 60lb, TA49, THDP, FTP cam, T+ lots o' shit - SOLD
'07 Ford F150 Lariat 2WD, 5.4L 3v - 255k
'20 Kubota BX2380. FEL, 60" deck
'78 IH/Case 184 Lo-Boy
'99 Kawasaki Bayou 400 4x4

Offline Charlief1

  • Just another kinky six
  • Turbo Street Eliminator
  • ******
  • Posts: 1348
  • PSI: 2
    • View Profile
Re: Heads with modified stems, ok for stock rocker shaft use?
« Reply #16 on: September 10 2011, 10:14:25 PM »
A little rough but you can clean them up easily Mark. If you want the bigger valves ect then I'd say go for it.
Logged
And remember, when dealing with children, silence may be golden but duct tape is silver.

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9905
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Heads with modified stems, ok for stock rocker shaft use?
« Reply #17 on: September 11 2011, 12:13:50 AM »
As I said, I would do it
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.
Pages: 1 [2]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal