Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hiboom

Pages: [1]
1
IHADAV8 Playground / Re: Let's see how ROck Auto handles this
« on: July 01 2011, 07:55:18 PM »
well you had better luck than i did ordered power steering pump was one of there close outs no core required about 65.00 when it arrived it looked like someone had installed it or it was a core return.i emailed them about it they asured me it would be fine.I took off a better one then the one from rock auto did not work at all.No replacement on close out parts.

2
General Buick Tech / Re: calling steve wood
« on: July 01 2011, 01:47:22 PM »
well steve you were right there is a+ and - on top of the pump had to put my reading glasses on to see it lol that what's happens when you get 50+ I bought the pump from turbo tweak when the bad batch came out was scared to use it.So I sent it back to eric and mike from ft sent me another one? I think eric was out I don't know for sure if it was bad,but didn't want to take a chance so it was replaced with another pump just got around to installing it.switched wires at the pump all is good now I just hate doing things twice.
thanks again

3
General Buick Tech / Re: calling steve wood
« on: July 01 2011, 06:34:06 AM »
Thanks steve no marking on the pump plug was different, wires were black and white it did have a hot wire to the 3 pin connector.i'll drop it this morning and trace the wire. thanks again

4
General Buick Tech / calling steve wood
« on: June 30 2011, 08:46:41 PM »
Maybe you can help me?I replaced my factory fuel pump with a walbro 2000169 the connector was different at the pump on the walbro so i cut the connector on the factory one laid the pumps side by side rewired the new pump (2 wires black and white)
apond starting the car the pump ran backwards but the fuel gauge worked so instead of droping the tank I switched the wired at the connecter now the pump works fine and the gauge don't work any ideas??

5
yea I bought one of there close out power steering pumps 60.00 didn't work from the moment I installed it.A real pos no replacement one available they want me to send it back for them to get it repaired then send it back.Like i'm going to wait 2 months to drive my car over a power steering pump.I'll never buy another thing from them.

6
IHADAV8 Playground / Is this how it is?
« on: February 12 2011, 10:12:55 AM »
It's the F***ing you get for the F***ing you got!

7
IHADAV8 Playground / Re: That's a big b!tch ! ! !
« on: February 07 2011, 06:19:50 PM »
Id need a ladder ! but still doable

8
IHADAV8 Playground / Re: Never Saw That Before
« on: January 14 2011, 01:26:00 PM »
boy that would suck not being able to go faster then that I would be a traffic haszard mine was a 460hp mack engine 13 speed road ranger 85 mph at 2300 rpm will run 74 in 12th so I can keep speed up to make all the hills(truck weighs 49800 emtpy) i wish i had a automatic though sure sucks shifting allday picking up and dropping off stuff

9
IHADAV8 Playground / Re: Never Saw That Before
« on: January 13 2011, 09:47:56 PM »
Talking safety I've run a moble crane 28 years.The bull shit we have to go through  just to set up and make a lift on a job site have so greatly changed it's almost unbeliveable.y ou have to have a prelift meeting with distances. working load limits, degree calulations of boom angle. max lift  capasity, persentage of max capasity of the crane per lift.I get tickled these young educated collage safety guys have know idea of the actual operation of the crane just what they have read.I allways tell them the only thing they need to know is about that one main lever.they say what lever is that? I say leave her alone.

10
IHADAV8 Playground / Re: Never Saw That Before
« on: January 13 2011, 03:10:19 PM »
Quote from: "DCEPTCN @ Thu Jan 13, 2011 10:45 am"
This was on Fairfax near I-70 on the KS side.

down by the old gm plant accross the intercity bridge i'm guessing?
I drive and operate a 26 ton moble crane for a construction co. in kc we do large com.building so I'm all over the kc area running around on a daliy bases.

11
IHADAV8 Playground / Re: Never Saw That Before
« on: January 13 2011, 10:12:46 AM »
I work in Kansas City, right down the road to broadway at folgers they do the same thing it least you get the good smell lol! so if you ever haul to them be ready!!

12
IHADAV8 Playground / Re: Favorite picture of your TR
« on: December 21 2010, 08:17:08 PM »
rosewood, when I bought the car it was black never dawned on me someone did a color change on it. and i didn't bother to ask.  flew out to az to pick up.On the ride from the airport the seller and I was discussing differerent turbo cars we had owned when I saw the car for the first time I had to laugh I realized all the cars he was talking about was the same car with 5 paint jobs and 3 different colors LOL! I've restored cars for 30 years so the paint was the least of my worries took 200 single edge razor blades to get it down to the factory weather checked paint.

13
General Buick Tech / Re: is the ta-49 still king?
« on: December 19 2010, 03:46:59 PM »
i have a 2006 monte carlo ss with the ls4 5.3 308 hp as a daily driver has good power 22 mpg but will not outrun my t tpye

14
General Buick Tech / Re: is the ta-49 still king?
« on: December 19 2010, 10:54:47 AM »
I have to go with steve on this one.I also like the 44 ,11's on a v6 perrty tuff to beat made alot of ford guys believers!!

Pages: [1]
SimplePortal 2.3.7 © 2008-2024, SimplePortal