15
« on: August 14 2023, 11:17:35 PM »
All right I am an IDIOT! I rechecked all my wiring and I found that when I installed my Caspers knock guage I wired it wrong. I hooked the signal wire to the ground terminal and vice versa. So I fixed that. Still getting code 43. The only scan tool I have is the Scanmaster. So following the flow chart I do not get the rpm drop unplugging the the esc. I also don't get the rpm jump if I remove the Jumper wire at terminal E. It all seems to point to a bad esc. NAPA shows a new one, I'm ready to try that.
Do you think it would hurt the car to drive it easy until I chase this down? I want to put some miles on before I install the front clip.