31
The Bastard Child Buick Board
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to. 31
Paint and Body / Freshly painted, new motor / trans, and lowered !« on: June 17 2013, 03:28:03 PM »32
General Buick Tech / Re: Need to be "fine tuned" in Maryland...« on: June 17 2013, 11:24:24 AM »
Paul Miller have a shop?
33
General Buick Tech / Need to be "fine tuned" in Maryland...« on: June 17 2013, 09:49:08 AM »
recommendation s?
34
General Buick Tech / Re: first PL file...Look ok?« on: June 12 2013, 01:28:30 PM »
Ok...makes sense to me. I assume that if 02's are good, af's should be in line as well??
35
General Buick Tech / Re: first PL file...Look ok?« on: June 12 2013, 10:22:52 AM »
Steve,
Should i switch WB's? 36
General Buick Tech / Re: first PL file...Look ok?« on: June 11 2013, 11:05:54 PM »
Steve,
I used the LC1 setting.... I have an email sent to Eric about the innovate MTX. It seems very similar to to the innovate LC1. 37
General Buick Tech / Re: first PL file...Look ok?« on: June 11 2013, 12:16:24 PM »
Thanks Steve...
I have the Innovate Motorsports 3844 MTX-L. And yes, 3 bar Map. 39
General Buick Tech / PL question....« on: June 10 2013, 09:27:11 AM »
I ran a few logs last night and noticed the a/f graph seems to bounce around a bit. Stays mostly between 10-3 to 11-8.. Is this normal? Thanks John
40
General Buick Tech / Re: In Car Boost controller ?« on: June 07 2013, 11:00:57 AM »
Your right ! whats 1-2 lbs
41
General Buick Tech / Re: In Car Boost controller ?« on: June 07 2013, 08:45:10 AM »
Steve,
You are correct about running rich at 20 lbs with Meth. I am running very rich at 20lbs with meth currently..(tuning now)..think im going to bump the boost to 23 this weekend....hop efully that will lean me out a tad. Also, bought the power logger to help. John 42
For Sale/Trade/Want To Buy / (4) 1985 GN wheels FOR SALE« on: June 06 2013, 12:11:42 PM »
decent condition. $300.00 (Buyer pays shipping) (301)520-9463 MIKE
* Call for info 43
General Buick Tech / Re: In Car Boost controller ?« on: June 06 2013, 11:37:47 AM »
Thats what i want to do.. Run 18-20lbs on street (93 and Meth) .. Then when i go to track, run a little 100 unleaded and dial boost up. Thought an in car controller would be easiest...
44
General Buick Tech / Re: In Car Boost controller ?« on: June 06 2013, 10:03:27 AM »
The chip was burned for 23-25lbs...(per Eric). I currently have the RJC controller and I plan to stay around 23lbs..Thanks for the help. John
45
General Buick Tech / Re: In Car Boost controller ?« on: June 05 2013, 01:17:53 PM »
Steve, i have the TT chip for my setup with Alky.. currently running 20lbs.. prob going to 23-25 once i figure out my false knock issue.. Would i need a new chip burned even though i have an Alky one?
|