Tech Area > Fabrication
cold air intake
Shimy87:
Made this over weekend. 3 inch exhaust pipe, sheetmetal shroud/box with 1/4 in slit hose around edges. Cut out area where stock filter housing was mounted to open to air under nose of car. Probably wont really do anything but it was a rainy day
earlbrown:
Without a lid it probably don't do much....
But the IAT reading will tell you if the air temp is lowered.
instro84:
nice looking project.
puzzledfox:
Did installing a cold air intake improve your ride's fuel efficiency and horsepower?
earlbrown:
Mileage will drop as the temps go lower.
Without some probes it's hard to tell if pressure in that box was higher or lower than normal.
If higher it probably won't make measurable power until you hit about 250MPH.
Navigation
[0] Message Index
[#] Next page
Go to full version