Tech Area > Fabrication
How to fix the sagging panels that is located under the dash
gnonyx:
For many years of no support, the fuse panel underneath the steering wheel gave it that bow sagging ugly look.
I used a flat steel bar, drilled both ends for existing panel support screws , hole saw for interior light, and then riveted the flat bar to the panel.
daveismissing:
Good stuff!
Scott87:
I like it, I need to do this myself.. How thick was the flat stock? Looks like 8th inch from the photo.
Posted From Tapatalk
SuperSix:
Great idea! I think you can get some aluminum bar stock at Home Depot.
Just a Six?:
--- Quote from: SuperSix on August 20 2012, 10:36:51 PM ---Great idea! I think you can get some aluminum bar stock at Home Depot.
--- End quote ---
Yup! I needed a few inches to make my double pumper hangar & had to buy a 3' length. I still have a good 30" left over so I'll add it to the list.
Navigation
[0] Message Index
[#] Next page
Go to full version