Author Topic: Rear End Axle Cover Plate  (Read 1717 times)

0 Members and 1 Guest are viewing this topic.

Offline gnonyx

  • Turbo Street Modified
  • *****
  • Posts: 505
  • PSI: 0
  • Boost n00b
    • View Profile
Rear End Axle Cover Plate
« on: May 06 2021, 10:00:37 AM »
Hi All,
Just want to know is it best to install the Fel-Pro gasket on dry or put a thin film of RTV?
Thanks
87 GN T-Top, ScanMaster, hot-wire kit, Full Throttle chips w/ matching 60# injectors, adj. fuel pump, and triple pod gauges w/ AEM A/F gauge, oil pressure gauge, vac/boost gauge, Kenne Belle rear seat brace, upgraded tranny w/ Art Carr pan cover, and a pre-lube oil system.

Offline nocooler

  • Administrator
  • Turbo Street Eliminator
  • ******
  • Posts: 1786
  • PSI: 3
    • View Profile
Re: Rear End Axle Cover Plate
« Reply #1 on: May 06 2021, 01:28:08 PM »
I always used ultra black with the gasket on the 8.5" 10 bolt. 9" just ultra black.
IhaveaV8

Offline gnonyx

  • Turbo Street Modified
  • *****
  • Posts: 505
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Rear End Axle Cover Plate
« Reply #2 on: May 06 2021, 06:16:17 PM »
I always used ultra black with the gasket on the 8.5" 10 bolt. 9" just ultra black.
Thanks for the info
87 GN T-Top, ScanMaster, hot-wire kit, Full Throttle chips w/ matching 60# injectors, adj. fuel pump, and triple pod gauges w/ AEM A/F gauge, oil pressure gauge, vac/boost gauge, Kenne Belle rear seat brace, upgraded tranny w/ Art Carr pan cover, and a pre-lube oil system.

Offline Tim Hensley

  • Turbo Street Modified
  • *****
  • Posts: 329
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Rear End Axle Cover Plate
« Reply #3 on: May 07 2021, 02:37:56 AM »
I like gasket and red wheel bearing grease
Arizona GN109 forged rotating assembly
DLS 210-210
Champion irons
Extreme Auto stage II trans and converter

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal