IHADAV8.com - Turbo Buick Tech, and Nonsense

Tech Area => General Buick Tech => Topic started by: dyermullet on September 21 2015, 05:42:27 PM

Title: pressure drop on pte stock location intercooler
Post by: dyermullet on September 21 2015, 05:42:27 PM

Has anyone measured the pressure drop on the PTE SLI?  I did some searching but didn't find the answer.

I was reading Steve's combination article, at the time Bob Dick didn't test the PTE SLI.  It probably wasn't being produced at that time.
http://www.vortexbuicks-etc.com/combination.htm (http://www.vortexbuicks-etc.com/combination.htm)

Title: Re: pressure drop on pte stock location intercooler
Post by: Scoobum on September 21 2015, 05:45:33 PM

PACECARTA will have it. Check with him on the other board.