IHADAV8.com - Turbo Buick Tech, and Nonsense

Tech Area => General Buick Tech => Topic started by: Shimy87 on May 23 2012, 02:13:30 PM

Title: Cleaning engine compartment
Post by: Shimy87 on May 23 2012, 02:13:30 PM

Got car soda blasted to remove original paint. Problem now is engine bay is COVERED in white dust. Compressed air aint doing the trick. I really want to avoid using water but dont think I have much of an option at this point. If I do resort to this option, it would be sparingly with a hose using a misting sprayer. Any specific places I should try to wrap with plastic first or are there just way to many to cover??
 
Thanks!!   

Title: Re: Cleaning engine compartment
Post by: Steve Wood on May 23 2012, 02:25:08 PM

I would cover up the coil pack and module connections

Then I would blast away.  When you are satisfied, blow dry it with the compressor.  If it is very greasy, spray some cleaner on it before blasting it

Title: Re: Cleaning engine compartment
Post by: motorhead on May 24 2012, 01:38:51 PM

You could use a diluted degreaser and a soft brush to loosen the grime up, then use a controlled stream of water to wash the gunk away.

Title: Re: Cleaning engine compartment
Post by: Just a Six? on May 24 2012, 01:46:21 PM

Cover the TPS & module as mentioned then go at it. I've done mine many times over the years & never had a issue. An old toothbrush & some cleaner works wonders.