87GN mods
Reds XP fuel pump- hotwired
TA54 turbo
009 Injectors
Reds chips 93, 100, 110 octane
Translator with LT1 3" maf
GNX fender flares
GNX emblems
GNX fender lovers
ported upper plenum
adj. fuel press regulator
3" downpipe
Hooker 2.75" exhaust
BQ trans built by Jimmyz in Chicago
Sfi approved flexplate
2800 rpm stall converter
has boost gauge in 3 gauge a-pillar pod also has knock sensor that has not been hooked up.
What it needs - front and rear bumper fillers, downpipe (long story but ut could use a new one), headliner, body panels aligned, rust repair on quarters (have quarters to go on it), horn trim ring, , rear tires, and of course paint.
85GN mods
GN1 heads with LT1 springs
2.5" up-pipe
Turbotweak chip
86/7 ecm
86/7 ignition module and coil pack
Limited slip rear end
HR parts n stuff rear suspension bushings
boxed upper and lower rear control arms
custom "6" headliner
electric fan
hotwired walbro 340 fuel pump
ported intake manifold
aluminum shifter handle
What it needs - front bumper fillers, maf/ translator or just a maf (used maf and translator on 87 when 87 maf failed), transmission (have brf from 87 that does not have 2nd gear but has upgrades and a D5 converter, also have another brf that was pulled from a t-type with a questionable converter but trans worked when pulled, neither are currently installed), may need an alternator, needs a battery
85 GN headliner
85 GN engine - coolant lines bypassed
85 GN
87 GN engine before the TA54
Short list of parts - driver and passenger quarters, 3 doors, door glass, shifter, hood emblem, seat belts, few interior trim pieces, clutch fan, extra transmission, a/c lines, vacuum block and hard lines, GNX body bushings, headlight buckets and lamps, headers, 8445 heads, etc...
Show Posts
