31
General Buick Tech / Re: Thoughts On 4.1 Liter Based Builds?
« on: December 30 2017, 09:13:47 PM »
I'm only able to view page #1. Won't show the pages after that.
How about fitting the 3.6+" forged stroker cranks into the 4.1 block?
What length rod is available that won't push the piston pin into the lower ring land?
Is a reduced base circle camshaft required to clear the connecting rods?
How about fitting the 3.6+" forged stroker cranks into the 4.1 block?
What length rod is available that won't push the piston pin into the lower ring land?
Is a reduced base circle camshaft required to clear the connecting rods?