IHADAV8.com - Turbo Buick Tech, and Nonsense

Tech Area => General Auto Tech => Topic started by: larrym on May 20 2015, 11:25:06 AM

Title: Helping a buddy out
Post by: larrym on May 20 2015, 11:25:06 AM
https://www.facebook.com/ryan.macleod.549/videos/168805873303221/

Hope you guys can see the vid watch the leave good 60' 1.48 ran a 10.6 at 121mph the Malibu hops out of the hole. He thinks he needs more front end travel I think he needs to soften the back and increase the rebound in the back?
And if you wait long enough that's me trying to run him down....
Title: Re: Helping a buddy out
Post by: Just a Six? on May 20 2015, 01:31:49 PM
Content unavailable?
Title: Re: Helping a buddy out
Post by: larrym on May 20 2015, 01:34:42 PM
its on his facebook account might have to log in to facebook to see it, I was afraid of that.
Title: Re: Helping a buddy out
Post by: gusszgs on May 20 2015, 05:51:16 PM
Larry, what is he running for suspension in the rear?
Title: Helping a buddy out
Post by: larrym on May 20 2015, 06:18:40 PM
Double adjustable QA coil overs and a Spohn ARB  control arms Spohn adjustable uppers.
Title: Re: Helping a buddy out
Post by: good2win22 on May 20 2015, 08:58:29 PM
I think your right Larry. Haven't watched the video but if he's hopping out of the hole, sounds like he doesn't have enough anti squat in the suspension. Stiffening the back may not compensate for too much squat in the rear.  How does he have the instant center set?
Title: Re: Helping a buddy out
Post by: larrym on May 20 2015, 09:32:15 PM
He has it set pretty stiff in the rear it lifts the front tires than it drops them looks like a hop not alot of squat. his thoughts are that the limited travel in the front is whats pulling back down

Title: Re: Helping a buddy out
Post by: good2win22 on May 20 2015, 09:51:37 PM
Instant center set too low then
Title: Helping a buddy out
Post by: larrym on June 04 2015, 12:22:49 PM
Well he modded his control arms to get more travel went from 3.5" to 5.5"
Title: Helping a buddy out
Post by: larrym on June 04 2015, 12:25:21 PM
We will see how this works out
SimplePortal 2.3.7 © 2008-2024, SimplePortal