Author Topic: Test N Tune friday night  (Read 5648 times)

0 Members and 1 Guest are viewing this topic.

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5557
  • PSI: 3
  • YOU CAN'T HANDLE THE TRUTH!!!!
    • View Profile
Re: Test N Tune friday night
« Reply #15 on: September 15 2013, 08:04:54 PM »
Your RPM's would be higher if your convertor slippage was high or the trans slipping in third. As Steve says your at altitude so that could be contributing to a lack of power in high gear.
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline trashmechlv

  • Turbo Street Limited
  • ***
  • Posts: 129
  • PSI: 0
    • View Profile
Re: Test N Tune friday night
« Reply #16 on: September 15 2013, 10:04:43 PM »
Scoobum, this is off topic but the Hoosier dot drag radials hooked like glue at 22lbs cold pressure. I know you said you got a set you didnt try yet. Thanks Steve I always appreciate your input.
Mike G

87 GN, TA52, ATR headers, 3" downpipe, 80lb inj's and TT 6.1 chip, CAS V4 IC, PTC 9.5 NL, B&M transcooler, stock posi rear 3.42, Hellwig rear bar, Spohn solid LCAs on E85! 11.46@ 115mph

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5557
  • PSI: 3
  • YOU CAN'T HANDLE THE TRUTH!!!!
    • View Profile
Re: Test N Tune friday night
« Reply #17 on: September 15 2013, 10:06:52 PM »
I'll try them at 22...thanks.
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline trashmechlv

  • Turbo Street Limited
  • ***
  • Posts: 129
  • PSI: 0
    • View Profile
Re: Test N Tune friday night
« Reply #18 on: September 17 2013, 01:40:59 PM »
Would a Dutt neck for my stock IC be a good mod for the cost?
Mike G

87 GN, TA52, ATR headers, 3" downpipe, 80lb inj's and TT 6.1 chip, CAS V4 IC, PTC 9.5 NL, B&M transcooler, stock posi rear 3.42, Hellwig rear bar, Spohn solid LCAs on E85! 11.46@ 115mph

Offline motorhead

  • Turbo Street Outlaw
  • *******
  • Posts: 2265
  • PSI: 4
  • look at my balls... look at them!!!
    • View Profile
Re: Test N Tune friday night
« Reply #19 on: September 17 2013, 01:53:45 PM »
Would a Dutt neck for my stock IC be a good mod for the cost?

Yes, it is proven.
>>>Das Instagram<<<
'80 LeMans Wagon|'87 Monte Carlo SS|'92 Camaro Z28|'07 TrailBlazer SS|'15 Colorado Z71|'19 Hellcat Widebooty M6

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9893
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Test N Tune friday night
« Reply #20 on: September 17 2013, 02:00:37 PM »
Probably not worth the effort. Save your money for an alky kit
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline larrym

  • Turbo Street Eliminator
  • ******
  • Posts: 1363
  • PSI: 1
    • View Profile
Re: Test N Tune friday night
« Reply #21 on: September 18 2013, 01:42:56 PM »
For slowing down with more boost would that not be the timing the ecm pulls slowing it down?
86 white T type with t tops and blackout trim. 60lb injectors Gen 2 with Extender Chip TR6 ignition 212/206 roller cam Turbonetics BB CPT 61 CAS V4 Intercooler Cobbled together Alky Injection 4 inch MAF pipe with integral sensor
2800 stall lots of fun with a little 6 banger!
Best ET 11.36

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9893
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Test N Tune friday night
« Reply #22 on: September 18 2013, 05:33:04 PM »
if it was pulling timing for knock retard.

Or, it might be that the turbo is making too hot of air charge which then means the air density is less, which then means the turbo is actually pumping less air into the engine in spite of the increased boost.
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline nocooler

  • Administrator
  • Turbo Street Eliminator
  • ******
  • Posts: 1791
  • PSI: 3
    • View Profile
Re: Test N Tune friday night
« Reply #23 on: September 18 2013, 08:10:22 PM »
1 - the D/A at the track that night was 4400ft - altitude is killing you

http://www.dragtimes.com/da-density-altitude-calculator.php?track=139&month=9&day=14&year=2013&getweather=Get+Weather+Data

Here is my take on it:

Reset the chip to the defaults.

Verify the fuel pressure - at idle.

Set the boost at 17-18psi and make a full 3rd gear pass - observe the 02 thru the pass. You are looking for a consistent 02 reading @ WOT. If it's bouncing all over the place you have an exhaust leak or bad sensor. Tweak the fuel in the chip until you get 780-800mv at WOT. Tune for ZERO knock.

Now you'll have a baseline.

Launch the car with as much boost as it'll hold without blowing the tires off. It might be 5psi, it might be 15psi.

Once you get the 60' consistent and have the launch down you are ready to add more power.

Now you can start upping the boost and adding fuel - just remember rich is not safe! If the MPH doesn't pick up then something isn't right.

It's been a few years since I played with a Buick - but keep it simple, the more changes you make a time the more issues you'll be chasing.






IhaveaV8

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal