Author Topic: torque spec pan bolts  (Read 3628 times)

0 Members and 1 Guest are viewing this topic.

Offline Shimy87

  • Turbo Street Eliminator
  • ******
  • Posts: 1238
  • PSI: 2
    • View Profile
torque spec pan bolts
« on: October 15 2015, 01:14:52 PM »
Whats the spec for pan bolts...rubber gasket....than ks guys
87 GN, K&N cold air, gutted cat, TT 5.7 chip, AFPR, 340 Walbro w/ hotwire, 60 LBS injectors, 981 valve springs, 206/206 Cam, RJC Powerplate, LS1 MAF & translator, Vacuum brakes, Hellwig rear sway bar, Energy suspension poly bushings, Razors Alky, Pypes exhaust, 5931 turbo, CK9.5 converter

Offline good2win22

  • Turbo Street Outlaw
  • *******
  • Posts: 2019
  • PSI: 0
  • No man lives happily lest he remove the boredom
    • View Profile
Re: torque spec pan bolts
« Reply #1 on: October 15 2015, 01:22:13 PM »
88 inch pounds.  You may want to retork after a heat cycle.  Good luck getting that torque wrench back up there after the heat cycles.  Some gaskets have a metal sleeve to keep you from squishing the gasket.  I don't recall the brand or part number.  Maybe one of the smart guys knows...
Jason

1966 Ford Ranch Wagon
1982 Jeep Wagoneer Limited
1986 Grand National BLK PHNX
1987 Turbo Regal Limited
2018 Ram 2500 Cummins

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9882
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: torque spec pan bolts
« Reply #2 on: October 15 2015, 07:09:00 PM »
transmission pan or oil pan?

transmission pan is 120-150 lbs-inch (not lbs-ft!}
« Last Edit: October 15 2015, 07:42:38 PM by Steve Wood »
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal