IHADAV8.com - Turbo Buick Tech, and Nonsense
Tech Area => General Buick Tech => Topic started by: Forzfed on August 10 2018, 03:01:47 PM
-
So, I have 3/4 of the kit installed and I am going to get a buddy to finish it off. Working nights so I can't spend much time on it. I put a little methanol in the tank and noticed it is leaking right where the braided line connects to it. Can you tighten that line?
-
I think that is a pressed in fitting and can't be tightened.
I had to get a new tank one time because of it
-
Ah, crap! :(
-
During the install Razor suggests using water just in case an occurrence like this happens...less corrosive spill. Good luck with the install and hopefully that works out. :rock:
-
Sounds like it's not going to work out! :icon_confused:
-
Sounds like it's not going to work out! :icon_confused:
This sounds lie something I ran into before.
Got a pic' or the offender without the hose on?
-
I talked to Julio yesterday. He said it is the same connection like a boost gauge. The fitting was very loose. So that is tightened up. But I ordered an extra tank for my inventory! :D