« previous next »
Pages: [1]   Go Down

Author Topic: How hard is it to change out the knock sensor?  (Read 4230 times)

0 Members and 1 Guest are viewing this topic.

Offline gordyzx9r

  • Turbo Street Eliminator
  • ******
  • Posts: 1067
  • PSI: 0
  • The Sultan of Swank
    • View Profile
How hard is it to change out the knock sensor?
« on: February 28 2005, 03:30:46 PM »
Just curious as to how to change out the knock sensor...and where it is located.  Just curious.
Logged

Offline AtomicBread

  • Turbo Street Limited
  • ***
  • Posts: 114
  • PSI: 0
    • View Profile
Re: How hard is it to change out the knock sensor?
« Reply #1 on: February 28 2005, 03:48:08 PM »
Behind the intake manifold, under the coil pack. Rear of engine, almost right in the middle. You can get to it from above the engine. should be cake. 14 ft-lbms, no teflon tape..

 :psix;
Logged
Jason
1987 Limited Turbo T
:horse:

Offline gordyzx9r

  • Turbo Street Eliminator
  • ******
  • Posts: 1067
  • PSI: 0
  • The Sultan of Swank
    • View Profile
Re: How hard is it to change out the knock sensor?
« Reply #2 on: February 28 2005, 03:53:38 PM »
Do you have to take out the coil pack to get to it?
Logged

Offline AtomicBread

  • Turbo Street Limited
  • ***
  • Posts: 114
  • PSI: 0
    • View Profile
Re: How hard is it to change out the knock sensor?
« Reply #3 on: February 28 2005, 04:13:03 PM »
I think it would make it easier, but you don't have to. I think there is enough room to work back there if you got small fingers..


 :psix;
Logged
Jason
1987 Limited Turbo T
:horse:

Offline Recklessrob

  • Turbo Street Outlaw
  • *******
  • Posts: 5112
  • PSI: 3
    • View Profile
Re: How hard is it to change out the knock sensor?
« Reply #4 on: March 02 2005, 12:37:40 PM »
I'd move the coil pack out of the way so you can see what you're doing.
Logged
Rob
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal