« previous next »
Pages: [1]   Go Down

Author Topic: Hello. New member here.  (Read 5184 times)

0 Members and 1 Guest are viewing this topic.

Offline OhioTurbo6

  • Newbie
  • *
  • Posts: 5
  • PSI: 0
  • Boost n00b
    • View Profile
Hello. New member here.
« on: September 05 2013, 11:26:48 AM »
Hi,
I'll be taking my new combo to the track tonight and see what it's got.
 
All built/tuned by me
109 + .030 over, TRWs, stock rods, stock crank, ARP bolts/studs, steel main caps, 204/214 cam, stock heads w/mild work, ported intake, 55# injectors, TT chip, 3" DP/46mm WG, stock intercooler, Hooker cat back, 340 pump/HW, LT1 MAF,
GT6776E turbo, 3400 stall, scanmaster & direct scan.
 
Race Gas, 28x9 slicks, I'm hoping for an 11 second pass.
Logged
87 GN

Offline gnonyx

  • Turbo Street Modified
  • *****
  • Posts: 505
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Hello. New member here.
« Reply #1 on: September 05 2013, 12:04:27 PM »
Welcome to a great forum, and great members
Good luck on your run post back with results
Logged
87 GN T-Top, ScanMaster, hot-wire kit, Full Throttle chips w/ matching 60# injectors, adj. fuel pump, and triple pod gauges w/ AEM A/F gauge, oil pressure gauge, vac/boost gauge, Kenne Belle rear seat brace, upgraded tranny w/ Art Carr pan cover, and a pre-lube oil system.

Offline SuperSix

  • Administrator
  • Turbo Street Outlaw
  • *******
  • Posts: 5071
  • PSI: 234
    • View Profile
Re: Hello. New member here.
« Reply #2 on: September 05 2013, 12:23:40 PM »
Welcome!!!
Logged
'87 GN, 60lb, TA49, THDP, FTP cam, T+ lots o' shit - SOLD
'07 Ford F150 Lariat 2WD, 5.4L 3v - 255k
'20 Kubota BX2380. FEL, 60" deck
'78 IH/Case 184 Lo-Boy
'99 Kawasaki Bayou 400 4x4

Offline OhioTurbo6

  • Newbie
  • *
  • Posts: 5
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Hello. New member here.
« Reply #3 on: September 05 2013, 12:24:27 PM »
Thanks!  I will let yall know how she does!
Logged
87 GN

Offline OhioTurbo6

  • Newbie
  • *
  • Posts: 5
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Hello. New member here.
« Reply #4 on: September 06 2013, 11:01:37 AM »
I only made 2 passes
Fuel 110 Turbo Blue
 
Pass #1
air bags L=11psi R=18psi
Slicks L=13psi R=13psi
1st/2nd Timing - 23.9
3rd Timing 21.9
Launch Boost - 8psi
Run Boost - 23psi
 
60` - 1.65  *video shows a lot of spinning*
1/8ET - 7.68
1/8MPH - 88.17
1,000`ET - 10.11
1,000`MPH - 100.47
1/4ET - 12.17
1/4MPH - 109.04
**820mv - Zero KR** - 83.9% Inj DC
 
 
Pass #2
air bags L=11psi R=18psi
Slicks L=13psi R=13psi
1st/2nd Timing - 24.9
3rd Timing 22.3
Launch Boost - 10psi
Run Boost - 25psi
 
60` - 1.69  *video shows more spinning than before*
1/8ET - 7.76
1/8MPH - 87.63
1,000`ET - 10.20
1,000`MPH - 99.76
1/4ET - 12.28
1/4MPH - 108.46
**800mv - Zero KR** - 83.0% Inj DC
 
 
 
Logged
87 GN

Offline SuperSix

  • Administrator
  • Turbo Street Outlaw
  • *******
  • Posts: 5071
  • PSI: 234
    • View Profile
Re: Hello. New member here.
« Reply #5 on: September 06 2013, 12:31:54 PM »
Nice!

Good job posting the data too, that will help others with the info.
Logged
'87 GN, 60lb, TA49, THDP, FTP cam, T+ lots o' shit - SOLD
'07 Ford F150 Lariat 2WD, 5.4L 3v - 255k
'20 Kubota BX2380. FEL, 60" deck
'78 IH/Case 184 Lo-Boy
'99 Kawasaki Bayou 400 4x4

Offline granitestategn

  • Turbo Street Limited
  • ***
  • Posts: 124
  • PSI: 0
    • View Profile
Re: Hello. New member here.
« Reply #6 on: September 06 2013, 03:00:06 PM »
Welcome! Sounds like you have the parts you need for the 11 second slip, might just need some tuning. Stock intercooler might be a little bit of a bottleneck but I would think you should still be capable. If you have the clearance, you might try letting a little air out of the bags. Might hook better? With a better 60 ft you should be there or close. My car is slow but there's some other guys here who may have some good input.
Logged
87 GN, 97K, original owner, stock turbo, stock IC, 60# inj, Turbotweak 93 chip, some other odds & ends

12.98 @ 104

Offline OhioTurbo6

  • Newbie
  • *
  • Posts: 5
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Hello. New member here.
« Reply #7 on: September 06 2013, 04:11:28 PM »
Thanks guys!  I'm using the ancient Direct Scan.  Can't give it up, lol
The intercooler is the only thing that is different from my last build.  I had a PTE FMIC several years back and the car went 11.50s on 25# boost.
Logged
87 GN

Offline Top Speed

  • Don't Tread on Me
  • Turbo Street Outlaw
  • *******
  • Posts: 2548
  • PSI: -2
    • View Profile
Re: Hello. New member here.
« Reply #8 on: September 09 2013, 10:13:39 AM »
Welcome to the board!!!
Logged
Champion Irons w/T&D roller rockers, TA-61 turbo, 206/206 Comp Cam,  57 lb/hr Siemens Injectors, 3000 stall PTC, PTE Plenum w/RJC Power Plate, 70 mm Accufab Throttle Body, RJC 325 Megacooler, TurboTweak 5.7/ Alky Control w/M1 methanol, 23 psig on the street, Puddn' Power engine, Borla Exhaust

Chris

Offline OhioTurbo6

  • Newbie
  • *
  • Posts: 5
  • PSI: 0
  • Boost n00b
    • View Profile
Re: Hello. New member here.
« Reply #9 on: September 09 2013, 10:17:40 AM »
Thanks!
Logged
87 GN
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal