Messages

166

General Auto Tech / Re: What to put a 383 stroker in?

« on: December 13 2014, 09:59:33 PM »

here's a change of pace:




they do stuff like this:

167

New Member Introductions and Welcomes! / Re: New member from Flint, MI

« on: December 13 2014, 08:35:57 PM »

Nope....I don't like boards where vendors control the information and their sins are hidden

How have you been doing? 

thats a good reason.


I'm doing really well, unfortunately that means my career was keeping me from enjoying my hobbies, and now that our buddy steve is retired from the chip business I've got my work cut out for me to get this thing tuned up right. On the other hand, I can afford to do it right for a change.

Welcome!

thanks!!

168

New Member Introductions and Welcomes! / New member from Flint, MI

« on: December 12 2014, 10:49:39 PM »

Hi everyone, I've had my GN since 1997... it was parked for the last few years, but I'm working on it this winter to get ready for this summer. Engine is out, inspecting the short block and putting it back together... so I figured I should study up.


So I get on the internet, and start reading, turns out a bit has changed since the last tune I had about 10years ago, hell even my scanmaster doesnt work anymore! So I figure I better find Steve Wood, and that led me here... What the crap Steve, did you get kicked off another board?
 


anyhow, here's the gameplan:
hydroboost
some form of new chip to replace my ME-R, fresh injectors
mildly ported heads (had a blown gasket)
9" converter (16930)
clean up some oil leaks, freshen up the oil pump
inspect the cam, get some new cam bearings, maybe throw a roller at it, if the stocker is wiped
monster sway bar