4"mass air

[shmed]

does anyone know what year make etc gm vehicle came with a 4" 100mm  mass air meter
i bought a translator  so i figured might as well go big lol

[Scoobum]

Walk into your friendly GM dealer and ask for a Z06...but you'll need the 3 to 5 pin connector from FT. I have the setup on my car.

[shmed]

do you have a part number?     year make model anything?

[Scoobum]

do you have a part number?     year make model anything?

No...but you can walk into any parts place and ask...and the parts guy will be able to cross reference it to each vehicle it was available on.

[Steve Wood]

be sure you have the adapters needed to connect it to your maf pipe

[motorhead]

http://www.tbssowners.com/forums/showthread.php?t=95071

I just built one for our TBSS through Summit and Amazon.

I am not certain how the MAF is scaled in the translator, but GM has about 6 different flow curves for this MAF depending on the vehicle application.  I have always been a little skeptical of how Bob approaches his integration of VE and MAF signals - not wrong, just different.

I will say that a MAF should be configured to the engine it is attached to, as there is no "one size fits all" solution.