1
General Buick Tech / Ball Joint Help
« on: February 14 2014, 04:42:52 PM »
So my question is.
How do I press in the upper control arm ball joints? Do I just hammer the sleeve in and then slide the ball joint in and tighten it? I assume that if I hit the sleeve in through the hole it will bend the metal?
Or am I going about this all wrong and the sleeve is on the bottom and you just slide the ball joint through the hole and button it up?
Sorry If I'm using the wrong terms.
How do I press in the upper control arm ball joints? Do I just hammer the sleeve in and then slide the ball joint in and tighten it? I assume that if I hit the sleeve in through the hole it will bend the metal?
Or am I going about this all wrong and the sleeve is on the bottom and you just slide the ball joint through the hole and button it up?
Sorry If I'm using the wrong terms.