General > Computer/Tech Support

Trying to get my powerlogger to read boost

(1/2) > >>

Robjob:
Im trying to hook my map to my powerlogger to get the boost readings. I followed the instructions on vortexbuicks on how to hook up the map to the powerlogger but I have know reading on my powerlogger. Is there a way to test to see if the map is working correctly? Also I checked the ground to the map and I don’t believe the map is getting ground. What would cause this?

good2win22:
Can't read the text in your original post. Might try changing the font size

TexasT:
Well, first thinks first, welcome to the site.

As far as the ground goes, you probably need to get out your meter and hit it to see if you are getting a signal from the boost sensing part to the pl where it is hooked In. Then you need to program that part of the pl to be looking for the boost input. I am sure it is in the instructions I downloaded off the turbo tweak site.

daveismissing:
What map sensor are you using?

wire in a voltmeter to test and get into some boost
or use a bunch of fittings, an air compressor and a regulator
voltages:
http://injector-rehab.com/shop/mapsensor.html

daveismissing:
I believe you need to set up the scaling in Power logger for your sensor? Somebody move versed can expand on that.

Navigation

[0] Message Index

[#] Next page