Author Topic: popping?  (Read 4921 times)

0 Members and 1 Guest are viewing this topic.

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5565
  • PSI: 3
  • YOU CAN'T HANDLE THE TRUTH!!!!
    • View Profile
Re: popping?
« Reply #15 on: August 29 2015, 07:45:32 PM »
Give a thorough check of the up pipe hoses/clamps. I think Brian Harper here in town had the same problem...and going to T bolt clamps on the up pipe hoses solved it. Was drawing air in under boost...making it sputter/pop.
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline earlbrown

  • Turbo Street Eliminator
  • ******
  • Posts: 1571
  • PSI: 6
    • View Profile
Re: popping?
« Reply #16 on: August 30 2015, 04:06:51 AM »
Under boost a leaky uppipe would vent, not suck.
'87 GN - 4.2L SFI Turbocharged innercooled V6 - Chrome valve covers - supra pump - 14" K&N - 52mm throttlebody - rocker shaft supports -  1/2 intake spacer - TB coolant bypass - 3" ATR exhaust tip - Alum intake pipe - NOS timing cover - chip - relocated charcoal canister - CR42's - stock

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5565
  • PSI: 3
  • YOU CAN'T HANDLE THE TRUTH!!!!
    • View Profile
Re: popping?
« Reply #17 on: August 30 2015, 07:36:24 AM »
Under boost a leaky uppipe would vent, not suck.

Suck...vent... whatever. It'll pop. :) He was getting so pissed off with the car he was ready to part it out. :icon_eyes:

Now...here's a question for everyone. If the exhaust cam lobe was going south...could the air/fuel mixture get forced out the intake valve...cuz it can't get out the exhaust...maki ng it pop?
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9898
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: popping?
« Reply #18 on: August 30 2015, 09:16:43 AM »
give us the o2s when it is popping
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline Pyro6

  • Turbo Street Eliminator
  • ******
  • Posts: 1327
  • PSI: 2
    • View Profile
Re: popping?
« Reply #19 on: September 08 2015, 07:14:43 PM »
Under boost a leaky uppipe would vent, not suck.

Suck...vent... whatever. It'll pop. :) He was getting so pissed off with the car he was ready to part it out. :icon_eyes:

Now...here's a question for everyone. If the exhaust cam lobe was going south...could the air/fuel mixture get forced out the intake valve...cuz it can't get out the exhaust...maki ng it pop?
It would depend on what cylinder during the event. More than likely the exhaust heat and pressure would overcome the vacuum with the intake valve open, and to what extent the intake valve is open. Nightmaring back to the carburetor days, if we dealt with a car backfiring (popping) through the carb, (in this case I figure intake plenum?) it was a timing issue (dist. cap included) or a lean misfire. So let's throw a turbo at it and lean becomes a whole other issue, like Earl said: wastegate performance. Just a thought.

Offline earlbrown

  • Turbo Street Eliminator
  • ******
  • Posts: 1571
  • PSI: 6
    • View Profile
Re: popping?
« Reply #20 on: September 09 2015, 12:45:13 AM »
Venting .vs sucking is more than trivial in a MAF setup.    Sucking raw air will introduce unmetered oxygen into the mix with can result in a lean misfire.   Venting from a boost leak will just waste performance.
'87 GN - 4.2L SFI Turbocharged innercooled V6 - Chrome valve covers - supra pump - 14" K&N - 52mm throttlebody - rocker shaft supports -  1/2 intake spacer - TB coolant bypass - 3" ATR exhaust tip - Alum intake pipe - NOS timing cover - chip - relocated charcoal canister - CR42's - stock

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal