Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - YGspider

Pages: [1] 2 3 ... 9
1
General Buick Tech / Re: additional leg room
« on: May 21 2014, 02:45:58 PM »
6,5 about.. !

2
Canada / Re: A Billion!
« on: April 15 2014, 05:09:36 PM »
Lmao that was so dumb when they announced they purchased those god damn seats....

3
Good looking build so far brother!  :rock:

4
General Buick Tech / Re: GBODY PARTS....
« on: March 27 2014, 02:33:11 PM »
I don't want to sound like a dick and go against everyone. But I never read into any of the vendors and Gbodyparts has treated me very well and I never pay any duty charges. I've spent well over 1500 with them and all the parts and service has been above average. I did see that thread about the burnt down GN and that sucks some serious ass....

5
It's coming along very well Mike, I need to paint my floors and put new sound deadener in this spring. How much for all the new sound deadener and where do you get it?  :rock: 

6
General Buick Tech / Re: Ball Joint Help
« on: February 16 2014, 05:58:23 PM »
 :rofl:

7
General Buick Tech / Re: Ball Joint Help
« on: February 15 2014, 01:39:50 AM »
Finished product


8
General Buick Tech / Re: Ball Joint Help
« on: February 14 2014, 09:02:22 PM »
Good find.

9
General Buick Tech / Re: Ball Joint Help
« on: February 14 2014, 07:54:06 PM »
top pic ...just tap it

Thanks that's what I assumed as well. Just wanted to make sure. From the factory they are riveted , my AC Delco pack has provided the hard wear and they should hold up.

10
General Buick Tech / Re: Ball Joint Help
« on: February 14 2014, 06:20:10 PM »
So out of these two images what is the correct way of bolting them in place?





11
General Buick Tech / Ball Joint Help
« on: February 14 2014, 04:42:52 PM »
So my question is.

How do I press in the upper control arm ball joints? Do I just hammer the sleeve in and then slide the ball joint in and tighten it? I assume that if I hit the sleeve in through the hole it will bend the metal?

Or am I going about this all wrong and the sleeve is on the bottom and you just slide the ball joint through the hole and button it up?

Sorry If I'm using the wrong terms. 


12
I find that the aluminum cracks at the mounting bolt holes due to torque straps and then vibrates once broken. The fix to this is do not use a strap and if you are making real power invest in poly mounts or get the RJC brace. I'm guessing the spring can give out but I'm positive you can fix that by buying a 1 inch shorter belt to stop it from clacking. In my Case my mounting bolthole is busted off. 

13
I've been dreading paying the price of a new one... haha I could buy much need parts for what seems to be a 80 dollar part for almost 400 dollars with shipping.  :013:


14
PM me if you have a good belt tensioner or a new tensioner.

Thanks, Justin :rock:

15
Kills And Thrills / Re: Vette Kill
« on: January 01 2014, 09:15:25 PM »
It's too bad I never got footage of that mustang you reeled in like a big fish haha that would a been awesome.

Pages: [1] 2 3 ... 9
SimplePortal 2.3.7 © 2008-2024, SimplePortal