Author Topic: TPS Adjustment  (Read 7943 times)

0 Members and 1 Guest are viewing this topic.

Offline gnonyx

  • Turbo Street Modified
  • *****
  • Posts: 505
  • PSI: 0
  • Boost n00b
    • View Profile
Re: TPS Adjustment
« Reply #30 on: February 24 2020, 03:19:51 PM »
will the plunger go any further in?  If it will, I would start at that point and see if the shifts occur at the normal speeds.  If the shifts are too high, then I would pull the cable back a notch at a time until the shifts are at normal speeds (part throttle) and assuming they are still firm and clean, I would leave it alone.
Thanks for the reply Steve
87 GN T-Top, ScanMaster, hot-wire kit, Full Throttle chips w/ matching 60# injectors, adj. fuel pump, and triple pod gauges w/ AEM A/F gauge, oil pressure gauge, vac/boost gauge, Kenne Belle rear seat brace, upgraded tranny w/ Art Carr pan cover, and a pre-lube oil system.

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal