it all started real good Wife was busy and even offered me her "go work on the car" Blessing. I get my stuff together and start the WB installation. put the car on the ramps and OHHH trans fluid everywhere OK worry about that later need to stay focused and finish the WB. Installed the sensor and ran the wiring backwards from the sensor to the cabin. Drilled the firewall fed the wires in, life is great so far. i get into the car and smell a sweet smell that i have unfortunately smelled before BUT what ever i am installing the WB, Next thing you know the carpet is wet and i actually see a drip of antifreeze coming from the heater unit anyway the WideBand is sortta done only need to connect it to the PowerLogger. but now i have to replace a heater core and transmission lines
I don't NEED an 11.50 or better time slip - I want I don't NEED N2O - I want I don't NEED an alky nozzle before the IC's inlet - I want I don't NEED direct port alky injection. - I want I don't NEED a WB - I want and the list goes on.
What i don't get why its so hard to embrace some one else ideas for their car NOT yours??
wrong and right i understand. But why the fuss about different.
just imagine going to a car show or the track and every single car is the same, wow that sounds like fun.
My car is my "stay out of trouble" hobby i love tinkering with it changing things around doing things different. [size=78%] [/size]
IDC close to 100 % and over a few times. Alky kit (Razors) maxed out anything close to 800 O2 got KR. Fuel pump going south?? TT5.7 chip 42.5 injectors Hot wired 340M (very old) TE-6031 Dutt Neck pocket ported heads (just a little) bigger valves. 3 inch TH type DP 93 pump gas
Went to church again Sunday morning i was able to control my self and not take any pictures of Vettes or Stangs even dough there was some very nice ones.
Are these CB128p (rod) MS960P (MAIN) good bearings? They are Clevite 77 made in the US. The target is 11.50s and LOTS and LOTS OF DD MILES. Thanks in advance guys David
Show Posts
OK worry about that later need to stay focused and finish the WB. Installed the sensor and ran the wiring backwards from the sensor to the cabin. Drilled the firewall fed the wires in, life is great so far.
